Steelworkers opinion------------- liquefying Steel requires higher temperatures then Jet Fuel can provide. Similar to propane it is cool burning, if it wasn't the internals of the jet engine would melt during normal operation! Anyone ever try to heat up a rusty Bolt with only propane? Good luck ! A combination of pure oxygen and Propane can cut steel. Blowing wind is not pure oxygen! At best it's compressed air, from my experience compressed air will eventually blow out a propane Flame, not really enhance it to a temperature that would liquefy Steel! I saw a video of pools of molten Steel pouring at a high rate from the corner of the building. I immediately knew no chance was that amount of liquid Steel produced by the jet fuel! Thermite is used to weld seamless railroad tracks, it is a casting process. Essentially pouring steel into a mold to bind the two pieces a railroad track for lack of better words. Thermite was used to melt the steel columns, in my opinion! Not even oxygen and acetylene could melt steel that thick that fast! Oxygen and acetylene mix are the most common gases used to cut steel!

Pretty impressed that they have managed to avoid all the COINTELPRO and speculative, less provable theories in favor of the irrefutable controlled demolition of WTC7.

Nothingburger

Forgive my lack of optimism.

Yawn.

About freaking time. I've been waiting for thia for nearly 2 decades.

So if jews tried to sink the USS Liberty, do you really think they'd hesitate to do the towers?